We carry a Quality Checked 90 day used vehicle limited warranty on all of our pre-owned vehicles under 8 years old and under 80,000 miles. The warranty is good for 90 days or 3,000 miles, whichever comes first.
Terms of the Quality Checked warranty are as follows:
· PARTIES TO THIS LIMITED WARRANTY: This Limited Warranty is between YOU and US
· DEDUCTABLE AND UNCOVERED COSTS: For each repair visit, YOU will be responsible for the first $100 of the cost of covered repairs, and for any other costs not covered by this Limited Warranty.
· LIMITED WARRANTY COVERAGE: In the event of Mechanical Breakdown of a Covered Part, WE (Benna Ford) agree to make repairs less applicable deductible, subject to the terms, conditions and limitations herein. Mechanical Breakdown means the failure of a Covered Part due to faulty workmanship or materials supplied by the original vehicle manufacturer or distributor. A Covered Part has failed when it can no longer perform the function for which it was designed solely because of its condition and not because of the action, inaction, or failure of any non-covered parts. IF THE MECHANICAL BREAKDOWN IS COVERED UNDER ANY OTHER WARRANTY, SERVICE POLICY, RECALL, OR REPAIR ADJUSTMENT ("OTHER COVERAGE") WE WILL PAY THE DIFFERECE, IF ANY, BETWEEN THE PAYMENTS DUE UNDER THIS LIMITED WARRANTY AND THE PAYMENTS DUE UNDER THE OTHER COVERAGE.
· ASSEMBLY NAME COVERED PARTS WITHIN THE ASSEMBLY:
o ENGINE: Engine block and cylinder heads and all internally lubricated parts including pistons, piston rings, pins and cylinder sleeves; crankshaft, pulley, mainbearings, caps and bolts; camshaft(s), camshaft bearings, buttons and plugs; timing gears and timing chain or belt; adjusters and seats; pushrods and lifters; oil pan, valve and timing cover, turbocharger/supercharger assembly including boost valve and wastegate; thermostat; seals and gaskets.
o TRANSMISSION/TRANSAXLE: Transmission/Transaxle case and all internally lubricated parts including ring and pinion gears; oil pump, cover, parking gear and pawl; roll pins; spags; sprockets; chain; springs; stator and shaft; pressure regulator valve; pressure switches; solenoids; bands; automatic transmission/transaxle clutch, drums, bearings; bushings; supports and shafts; control rings; yoke; extension housing; transmission mounts and modulators; seals and gaskets. (STANDARD TRANSMISSION CLUTCH ASSEMBLIES AND ALL COMPONENT PARTS ARE NOT COVERED.)
o DRIVE AXLE: Differential/axle housing(s) and all internally lubricated parts including the axle flange; ring and pinion gear/carrier assembly; spider gears and bearings; pins; retainers; positraction clutches, plates and springs; cover. Transfer case and all internal parts contained within the transfer case. Drive shafts, axle shafts, bearings, wheel bearings, prop shafts, U-joints and constant velocity joints; seals and gaskets.
o BRAKES: Master cylinder, brake booster assembly, hydraulic lines and fittings, combination valve, calipers, wheel cylinders; seals and gaskets. (ABS components not covered).
o STEERING: Steering gear housing and internal parts including control rings, valves, pinion shaft, pitman shaft, worm shaft and gear, sector shaft, bearings, adjusters; rack and pinion housing and internal parts including control valve, rack bellows, mounts, rack shaft and yoke, spool valve, bearings; power steering pump and internal parts including housing, reservoir, shaft and vanes; seals and gaskets, tie rods, idler and pitman arms, center link, coupling and shafts.
o ELECTRICAL: Alternator housing and all internal parts including bearings, bushings, brushes, rectifier bridge, diodes, field coil and rotor; starter motor housing and all internal parts including bushings, brushers, field windings, starter drive and solenoid, voltage regulator, windshield wiper motor, power window motor, power seat motor, headlight switch, wiper motor switch, turn signal switch, mirror motor switch, stoplight position sensor, vehicle speed sensor, map sensor, knock sensor and barometric pressure sensor.
o AIR CONDITIONING: Condenser, compressor, clutch assembly, evaporator core, orifice, POA valve, automatic temperature control, idler pulley, accumulator and receiver drier.
o SUSPENSION: Upper and lower control arms, control arm shafts, struts, spindle, spindle support, ball joints, bearings and bushing, kingpin and bushings, stabilizer bar and bushings.
The information listed above is for informational purposes only.